[Chameleon] do not show layers in legend
anthony.k.farrant at gmail.com
Mon May 14 05:16:08 EDT 2007
I didn't know there was actually a difference between a STATUS DEFAULT
and a STATUS ON. Now I know.
On 5/14/07, Delfos, Jacob <Jacob.Delfos at maunsell.com> wrote:
> I explained this once here:
> To make it not appear at all, but always show, use "STATUS DEFAULT". To
> make it depend on another layer, simply give it the same name as that
> other layer (they will switch on-and-off at the same time). In the
> latter case, comment out the GROUP name (otherwise it switches on as
> soon as any layer in that group is on).
> > -----Original Message-----
> > From: chameleon-bounces at lists.maptools.org
> > [mailto:chameleon-bounces at lists.maptools.org] On Behalf Of
> > anthony farrant
> > Sent: 13 May 2007 00:56
> > To: chameleon at lists.maptools.org
> > Subject: [Chameleon] do not show layers in legend
> > Me again. (I'm doing overhours)
> > Does anybody know how to inhibit showing some layers in the legend?
> > Thanks,
> > -A
> > _______________________________________________
> > Chameleon mailing list
> > Chameleon at lists.maptools.org
> > http://lists.maptools.org/mailman/listinfo/chameleon
> This email and any attachments are intended solely for the named recipient and are confidential. The copying or distribution of them or any information they contain by anyone other than the named recipient is prohibited. If you have received this document in error, please notify the sender and delete all copies from your computer system and destroy all hard copies. It is the recipient's responsibility to check this email and any attachments to this email for viruses before use.
More information about the Chameleon