[maplab-users] GMAP problems

[Paul Dymecki]

Hi Daniel,
     The scenario is i have upgraded to mapserver4.4beta.  A previous GMAP
program is now not working,  for some reason except when i comment out the
projection sections from the mapfile(of course the map does'nt display
properly)  The same goes for the Tutorial map that comes with maplab ie.
works fine until i add the following projection:
PROJECTION
    "init=epsg:42304"
 END

Also my old GMAP application does display fine in mapedit preview section,
so i was wondering if i could do code substitution somehow.  ie.  copy over
the code from mapedit to gmap?
thx for any ideas....
Paul

----- Original Message ----- 
From: "Daniel Morissette" <dmorissette at dmsolutions.ca>
To: "Paul Dymecki" <pdymecki at sympatico.ca>
Cc: "MapLab-users" <maplab-users at maptools.org>
Sent: Friday, November 26, 2004 2:56 PM
Subject: Re: [maplab-users] GMAP problems


> Paul Dymecki wrote:
> > ok a bit further along;  on commenting out the projection section of the
map
> > my base layers are then viewable so it's definitely a projection
problem..
> > Paul
> >
>
> I didn't follow this whole thread, but have you considered sharing your
> mapfile with the list? I'd suspect an incomplete PROJECTION definition.
> That's what the error message tells us:
>
> >>>
> >>>>>2004 - msProcessProjection(): Projection library error. projection
not
> >>>>>named\r
>
> Daniel
> -- 
> ------------------------------------------------------------
>   Daniel Morissette               dmorissette at dmsolutions.ca
>   DM Solutions Group              http://www.dmsolutions.ca/
> ------------------------------------------------------------