[Mapserver-users] Fill Polygons

[Paul Spencer]

Note that this makes the entire layer transparent, including polygon 
outlines.  If you want solid outlines and tranparent fills, you will 
need two separate layers.

Paul

Bart van den Eijnden wrote:
> Hi,
> 
> you can use TRANSPARENCY for this, see:
> 
> http://mapserver.gis.umn.edu/doc40/mapfile-reference.html
> 
> TRANSPARENCY [integer]
> Sets the transparency level of all classed pixels for a given layer. The 
> value is a percentage (0-100) where 100 is opaque and 0 is fully 
> transparent.
> 
> Best regards,
> Bart
> 
> On Thu, 20 May 2004 13:19:47 +0200, Scott Ainslie <dmi@webmail.co.za> 
> wrote:
> 
>> Can I make the fill color of polygons transparent, ie: able to see layers
>> underneath?
>>
>> Thanks
>> Scott
>>
>> _______________________________________________
>> Mapserver-users mailing list
>> Mapserver-users@lists.gis.umn.edu
>> http://lists.gis.umn.edu/mailman/listinfo/mapserver-users
>>
> 
> 
> 

-- 
  -----------------------------------------------------------------
|Paul Spencer                           pspencer@dmsolutions.ca   |
|-----------------------------------------------------------------|
|Applications & Software Development                              |
|DM Solutions Group Inc                 http://www.dmsolutions.ca/|
  -----------------------------------------------------------------

_______________________________________________
Mapserver-users mailing list
Mapserver-users@lists.gis.umn.edu
http://lists.gis.umn.edu/mailman/listinfo/mapserver-users