[FWTools] Newb problem - exporting

Geoff Mark geoff at geoffmark.com
Wed Feb 22 01:12:59 EST 2012


I'm not completely comfortable with CLI, but I think this might be a 
lost cause.  Using gdal_translate I get:

"'w001001.adf' not recognized as a supported file format."

This is the same file that loaded fine into OpenEV_FW.  OpenEV opened 
the file, I could see its loveliness, but I'm guessing it was too big 
(475 Mb.)

Can you think of another solution?

Best Regards,
Geoff

On 2/21/2012 4:46 PM, Frank Warmerdam wrote:
> On Tue, Feb 21, 2012 at 12:10 PM, Geoff Mark<geoff at geoffmark.com>  wrote:
>> Thanks for responding Frank.
>>
>> Is this what you're looking for:
>>
>> Size: 10812P x 10812L x 1Bands
>> Driver: GeoTIFF
>> Origin: -120.000555556 40.0005555556
>> Pixel Size: 9.2592592593e-005 x 9.2592593e-005
>> Projection:
>> GEOGCS["NAD83",
>>     DATUM["North_American_Datum_1983",
>>         SPHEROID["GRS 1980",6378137,298.2572221010002]],
>>     PRIMEM["Greenwich",0],
>>     UNIT["degree",0.0174532925199433]]
>> Metadata:
>>     AREA_OR_POINT: Area
>> Band  1: Type=Float32
>>
>> Looks like raster?
> Geoff,
>
> Yes, definitely a raster.
>
> GDAL does not support raster output to DXF or OBJ (as far as I know).
> So you pretty much
> need to fallback to some other DEM format.  You mention "DEM" which
> I'd guess is likely
> USGS ASCII DEM format.
>
> You can try doing:
>
>    gdal_translate your.adf -of USGSDEM out.dem
>
> At the FWTools commandline.  This will produce a USGS ASCII DEM
> file which might work with your software.  If you need to produce something
> matching a particular product profile it is more involved, but in that case
> read over:
>
>    http://www.gdal.org/frmt_usgsdem.html
>
> I presume you were actually doing the import and export from
> within OpenEV?  I'd suggest doing the translation from the
> commandline using gdal_translate as I vaguely suspect there
> are limits on the capabilities of the OpenEV export tool.
>
> Best regards,




More information about the FWTools mailing list